Govee Hexagon LED Wall Supports
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Edge, inside corner, and outside corner nailable supports for Govee Hexagon LEDs
- Ocena
- 0 / 5
- Polubienia
- 22
- Pobrania
- 119
- Wydruki
- 1
- Wyświetlenia
- 1294
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
The Govee Hexagon LED tiles normally use a removable double-stick foam tape for mounting. This is not particularly reliable on textured drywall. These supports allow you to use small nails with the supports to hold the panels more securely. They are also reusable, unlike the foam tape.
They are designed for use with #17 wire brads (1.5 inch or 1.25 inch long) like the Hillman brand available at Lowes. The supports are 19.2 mm (0.76 inch) high. As I discovered, print more than you think you will need. I printed twelve of each for ten LED panels and barely had enough. The small ledges on the backs make it easier to lever them out of the wall with a flathead screwdriver or similar tool.
I printed these with white PLA to match the panels.
- 0.4 mm nozzle
- 0.2 mm or 0.25 mm layer height
- 2 perimeters
- 4 (or more) solid layers top and bottom
- 50% rectilinear infill for strength
- No support
I've included STL, STEP, and Fusion 360 files.