Hex drill adaptor for generator coil winding
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple part to attach a hex bit to a drill for winding coils for the Tom Stanton hand cranked generator.
- Ocena
- 5 / 5
- Polubienia
- 56
- Pobrania
- 365
- Wydruki
- 1
- Wyświetlenia
- 2484
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial
I was building my own version of Tom Stanton's hand cranked generator: https://www.printables.com/model/658157-hand-crank-generator
My first attempt at winding the coils by hand wasn't pretty, so I designed this part to allow a drill to attach using a 6mm hex bit. Combined with an optical tachometer, this allows fast coil winding with a precise coil count.
I would recommend drilling out a pair of coil templates, plus a single coil stiffener from the original files with a 3mm drill bit. Then use two M3 x 25mm bolts through those parts and into the hex adaptor. It is sized so that the M3 bolts will cut their own thread..
I covered my version of this project in the following video: