Formula/GT3 Carbon Fibre Steering Wheel & Arduino Shift LIght
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Build your own DIY Formula/GT3 style Carbon Fibre Steering Wheel & Arduino Shift LIght
- Ocena
- 0 / 5
- Polubienia
- 25
- Pobrania
- 346
- Wydruki
- 0
- Wyświetlenia
- 1855
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
Here's my design for Carbon Fibre Formula or GT3 style steering wheel with sequential shift light.
I made this for my Mazda MX5 track car but the wheel uses a standard bolt pattern that will work for mostly any vehicle.
While the wheel base was made with CF, the grips and shift light are all 3d printed.
Also attached is the arduino code for the Nano for the sequential shift light.
Electrical Components used:
- Arduino pro micro, nano etc:
- 70mm x 40mm Prototype PCB
- 5v voltage regulator #7805
- Heatsink #V4330N
- 1000uF (~16v) capacitor
- PNP transistor #2N3906
- 47k ohm resistor
- 10k ohm resistor
- 300-500ohm resistor
- Neopixel 8LED strips #WS2812
Additional/optional considerations:
- Wire to connect between the car, the Arduino and the LEDs
- Your choice of connectors, I used a 3-pin Deutsch DT & GX12 connector
- Tools such as soldering iron & solder, wire cutters, etc.
- Heat shrink
- Breadboard: https://aliexpress.com/item/1005001704653648.html
Link to circuit to build for shift light:
https://crcit.net/c/38f61c6bf2ca448b873acab04ba2b8e6
There are two versions of the 'case' for the LED shift light, one that mounts to the steering wheel, and another that is 'standalone', ideal for mounting to somewhere else on the dashboard of your car.
As seen in the video DIY Carbon F1 Wheel: Building a Sequential Shift Light - DIY GUIDE - YouTube