Storm Planter Trooper Thicker
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of Taboy's Storm Planter Helmet from Thingiverse making the wall another layer thicker.
- Ocena
- 5 / 5
- Polubienia
- 27
- Pobrania
- 125
- Wydruki
- 5
- Wyświetlenia
- 651
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial
This is a remix of Taboy's Storm Planter Helmet
I dropped the original STL into Meshmixer and extruded the inner wall by one more line thickness (.042mm) making it just a little more sturdy. I printed it with the crappiest white PLA I had and it printed without internal supports and minimal boogers, looks pretty decent. With a .2 layer and 50mm/s it takes under 12 hours to print from the original 8.5 hours. I'm still learning Meshmixer and for the life of me I could not figure out how to keep the file size down.
Print Settings
Printer Brand:
Anet
Printer:
A8
Rafts:
Doesn't Matter
Supports:
Yes
Resolution:
.2
Infill:
20%
Filament: Any PLA+ or something sturdy / UV resistant / heat resistant White
Notes:
In Cura it will throw an error saying there are extraneous layers but it did print successfully. Just check the preview and make sure "print thin walls" is checked.
I always print with 3 layers to avoid and infill showing through and that seems to work well.You should be able to print using a .6mm nozzle with close to a .6 line width. The details may suffer but it should still be pretty strong.
Category: Outdoor & Garden