Silencer For .177 Airguns (Zoraki etc.)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Airgun silencer that clamps on to the barrel. Parametric design for barrel diameters and calibres. Not for firearms.
- Ocena
- 0 / 5
- Polubienia
- 34
- Pobrania
- 472
- Wydruki
- 0
- Wyświetlenia
- 2011
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- GNU General Public License v3.0
An airgun silencer, model supplied for .177 calibre, with K-type baffles that prints without support. Particularly useful for silencing CO2 and pneumatic airguns. Firearms will just blow it to bits and may present multiple hazards, so don't do that.
The silencer, technically a moderator, clamps on to the 18mm barrel with a 25mm M4 screw and nut. If it is a very tight fit, dip the clamp end in hot (not boiling) water to make it a bit more compliant. Do not overdo the warming or you will put the silencer out of alignment.
Printing
Print without support, a minimum of 4 layers and 30% infill, muzzle end down. A raft is highly recommended as the model is tall and thin.
Modification
The OpenSCAD files allow you to change the calibre, barrel diameter, and the number of chambers in the silencer. Do not modify the design for very large diameters, or you won't see your sights!
If you don't do OpenSCAD, you can haul the design into TinkerCAD and modify it manually from there.
Notes:
This was designed in 2012, printed in impact-modified PLA, and lasted 10 years. Modern 3D printers like the Prusa can do a much better job of printing it! I use it on a Zoraki pneumatic air pistol for rodent control at night - the rest of the family frankly don't want to know about the rodent control thing. The Zoraki has sufficient power and accuracy for humane use, but is also very noisy. Do not use low power airguns for pest control, particularly pistols conforming to EU regulations.