White Kyurem Overdrive - Pokemon

Merry Christmas everyone ! … wait … we are in february. It took way longer that expected but i took the time to make it look as good as possible and as easy as possible to print.

The White Kyurem from Pokemon is finally here!

Printed in 7 parts for optimal quality and ease of printing. Assembly using putty (I recommend Tamiya putty) for near seamless joining.

Part-by-part precision guide:

Part 1 : The base. No supports needed. Print at 0.15mm layer height for a clean finish. 10% infill, gyroid pattern. Approx. 9h30 print time*.

Part 2 : The legs. Use tree supports or grid supports. Print at 0.10mm layer height for detail. 15% infill, gyroid pattern. Approx. 8h10min print time*.

Part 3 : The body. Hardest part to print. Print at 0.10mm layer height for detail. Grid support recommended. Approx. 6h20min print time*.

Part 4 : The Tail. Easy to print. Use tree supports. Print at 0.10mm layer height for detail. 15% infill. Approx. 9h50min print time*.

Part 5 : Cables. Print with tree supports. Sand and paint for perfect finish. Print at 0.10mm layer height for detail. Approx. 2h20min print time. (Couldn't manage perfect round cables but you don't see the imperfections after sanding and painting)

Part 6 : The Head. Print at 0.10mm layer height for detail. Grid support recommended. Approx. 2h print time*.

Part 7 : The Horn. Easy print with tree supports. Print at 0.10mm layer height for detail. Approx. 6min print time*.

*Print speed of my printer : 80mm/s infill and 45mm/s perimeters. (Stock SV06)