Tiny weather station housing - ESP8266-01 + 0.96" OLED
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Housing for tiny ESP8266 weather station.
- Ocena
- 4 / 5
- Polubienia
- 9
- Pobrania
- 117
- Wydruki
- 1
- Wyświetlenia
- 848
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
brThis is a small housing for a weather station build according to ThingPulse's project (https://github.com/ThingPulse/esp8266-weather-station).
It can house an 0.96" 128x64 I2c OLED display, an ESP8266-01 (even soldered on perfboard fith 3.3 V regulator), small Li-Ion battery (for example from a disposable e-cigaret) and an USB-C TP4056 charge and protect module (this type). The TP4056 module is held in place with doublesided sticky tape and is placed in the recess.
You don't have to use the battery and you can use the TP4056 module just as an USB breakout for 5 V power.
The display is held in place with 4 M2.5 screws and nuts and the floor is connected to the body with 4 M3 countersinking screws (they thread into the printed plastic holes, so drill those to 2.5 mm before screwing).
Use supports on the body under the bottom screw holes. You can also add small supports to the middel of the display window, if you do not trust you printers bridging ability. The roof of the body prints no problem without supports.
Material: PLA (any common material will work)
Layer height: 0.2 mm
Perimeters: at least 3
Infill: does not matter
Print all the files in their final orientation, use brim (!) on the body.