Tasogen Hygrometer Insert for Praki 4L Container Lid - Slimfit & Removable
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Lets you toss a hydrometer into the Praki lid for filament storage
- Ocena
- 5 / 5
- Polubienia
- 12
- Pobrania
- 89
- Wydruki
- 1
- Wyświetlenia
- 453
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I wanted an insert for the Praki containers (used for filament storage) that consumed less material, didn't bind the hydrometer so much, and was easier to remove.
This one takes a bit less than half the filament and also has a notch in back to assist with removal at different angles.
Also, the hydrometer is easier to get in and out.
The design has a few bumps on the exterior - points of a hexagon that are filleted over. The intent was to allow the object to friction fit tight enough to handle a direct smack on the lid from above. These managed, but if it's not strong enough for you, just cut the fillet down a little more.
Should be fine to print…
- Without supports
- 3 walls
- 2 walls is fine, but be sure to check the seams - they tend to land at the corners and can break easy
- 10% infill
- 0.2-.28 mm layer height (what I tested on a .4mm nozzle)
Printed on a Bambu A1 Mini.
In theory, the F3D file's parameters can be tweaked for different square-shaped hydrometers, but I have only tested the Tasogen ones.