Target spotting camera and display
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Solution eliminates negative influences (eg. mirage etc.) when observing the target in long range shooting .
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 731
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The solution is designed to improve the target spotting during long range shooting. It uses technology used by FPV drones, planes etc.
It consists of two basic components:
- The camera, transmitter, accu (1xLiPo 3S1P 2700mAh) module;
- Receiver module (optional, see note below), designed to be mounted on 30mm tube rifle rest (Gehmann in this particular case), used for spotting scope. This module holds the receiver, 2xLiPo 3S1P 2700mAH, and the display.
Note: You can omit entirely the Receiver module and use mobile device (phone) with appropriate receiver. External power source for the receiver will be needed in such case, as the receiver consumption is not low.
Electronics used:
- RC FPV Combo System 5.8g 200mw Wireless TS351 Transmitter RC805 Receiver HD Monitor CCTV Camera: https://www.aliexpress.com/item/32667753799.html
- For mobile connection, you can use ROTG01 receiver: https://www.aliexpress.com/item/4000693540615.html Don't forget to check your mobile device for UVC support!
Do not forget to check and comply with local regulations (FCC) related to radiated power and frequency when choosing the transmitter!
Other components:
- Tripod for camera/transmitter module of your choice - the mount provided is compatible with GoPro mounts
- LiPo accus of your choice;
- Bolts and self tapping screws for plastic (see rsdoc model file).
This is a multipart print. Gcodes or slicer files are not provided, as I assume modifications according to electronics you'll use (I used what I found in drawer as leftovers from other projects).
General print instructions (no special requirements):
- Material suggestion - PLA or PETG;
- Support on buildplate only for part "Transmitter_module_upper", otherwise no support needed.
- Layer 0,2 - 0,25mm
- I recommend to use brim to eliminate warping