Eufy RoboVac 11 replacement filter lid
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This will replace the lid that covers the dust filter in a Eufy 11[S/+] rubbish compartment, if the original breaks.
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 27
- Wydruki
- 0
- Wyświetlenia
- 299
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The hinge on the original filter lid for my Eufy 11S broke, finally, after years of abuse. Picture of the original included (blue) for reference. Using this, and a pretty good guess at how the hinge was supposed to work, I drew this replica.
Once printed, the lid should just pop into place where the old one broke off. After some initial testing, and borrowing the gasket from the old lid, it seems to work fine. Without the original gasket, some sort of cut foam might work to seal this.
I printed this in solid PETG, with supports for the arch on the clasp mechanism, and it is plenty study. The clasp is supposed to flex, so PETG is probably a better choice than PLA, but PLA would work in a pinch.