Hygrometer Sensor Holder for Sunlu Dryer
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Modified sensor mount for the Sunlu filament dryer.
- Ocena
- 4,8 / 5
- Polubienia
- 31
- Pobrania
- 203
- Wydruki
- 6
- Wyświetlenia
- 1472
- Oceny
- 5
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial
I modified this mount to fit the actual sensor better. The hole itself was perfect, but there was no room for the clips on the sides. I added a small indent on both sides to let the sensor slide in, now its nice and snug and you don't have to cut away any material to make it fit.
Might see if I can integrate the “nut” into the mount itself.
I've included the original nut and bolt which is recommended to be printed at 0.1mm layer height. I printed the holder at 0.2mm on its side without supports. The bolt hole definitely doesn't need supports, sensor hole may need supports if you printer doesn't bridge well.
Printed in PLA
Holder @ 0.2mm (consider supports on sensor hole)
Nut/Bolt @ 0.1mm (recommended by original creator, haven't tested other layer heights.)