1 / 7

Big Einsy Case for Bear Upgrade

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A remix of Boogie's Big Einsy Case to mate with the Bear Upgrade

Aktualizacja u źródła: 22 lip 2021

Informacje o modelu

Notable changes

Geometry added to mate with the Bear Upgrade V-Slot Extrusions
- Use either drop-in or standard T-Nuts
- Use either M5-10 socket head or M5-8 flat head screws
- Temporary M3-12 screw added to aid in sliding T-Nut alignment.
Case is 3mm wider to accommodate M5 socket head screws
Vent pattern inspired by Prusament filament spools.
Extruder cable clamp diameter reduced to 13mm with tie wrap securing.
The square and hex nut cavities were resized for better retention.

Printing

Layer height: 0.3mm Draft
Supports: “Support on build plate only” with painted support blocking. See .3mf file for details.
Filament: Prusament PETG

Mounting to Bear Upgrade Frame

Required Hardware
- 6 M3 square nuts
- 4 M3 hex nuts
- 4 M3-10 screws
- 2 M3-25 screws
- 4 M3-10 flat head screws
- 3 M5-10 socket head or M5-8 flat head screws
- 3 M5 T-Nuts, drop-in or sliding
Clean out all holes with a 3mm or 5mm drill bit. Pay particular attention to the four cover mounts. The 3mm hole extends fully through the mounts to aid in clearing debris.
Insert six square nuts, four in cover mounts, two in the clamp.
Insert four hex nuts into the back by drawing them through with a M3-12 or larger screw.
Remove the vertical extrusions's top plate and insert a sliding T-Nut if available.
Insert an M5 screw in the single V-Slot hole nearest the back. Partially thread a drop-in T-Nut and secure the case to the frame. Using a drop-in T-Nut precludes the need to remove gussets.
Slide the two sliding T-Nuts to the top of the extrusion. Insert a temporary M3 screw hole as shown. Then, let gravity slide a T-Nut into position and secure. Repeat for second _T-Nut.
Install the Einsy board with four M3-10 screws.

Wiring

I found the following order worked well for me.