Espresso Brush Stand
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A holder for your coffeebrush or whatever you need a holder for!
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 22
- Wydruki
- 1
- Wyświetlenia
- 173
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial
For everyone who's also fed up with the coffeebrush rolling underneath the porta machine or having it laying around on the counter to fall on the floor: I build this stand for a clean organized desk, that also fits the theme ☕
Of course you can hold anything else with it too - from pencil to toothbrush!
The inner diameter measured on my printed stand is 13mm.
My brush has a diameter of about 12mm on the tip, that's the maximum to guarantee an easy slide in.
I made two stl files:
One with an angled edge on top, so it can slide in easier.
The other with a sleek flat edge for a more stable hold.
The Latte Art decor on the side was designed by Lana Bauer from Noun Project
Print Settings
Printer Brand:
AnkerMake
Printer:
AnkerMake M5
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.2
Infill:
20%
Filament: GiantArm PLA New Black
Notes:
I enabled ironing on the top layer for a smoother look.
If you want to have even better details you could change the resolution to 0.1
My print worked fine without any supports - the handle looks a bit fuzzy on the bottom side, perhaps it's no mistake to use a support there. Or just reduce the printing speed.