Flysky FS-i6 FS-i6x Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case and insert for Fkysky FS-16 Transmitter
- Ocena
- 0 / 5
- Polubienia
- 35
- Pobrania
- 381
- Wydruki
- 0
- Wyświetlenia
- 1723
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a case and insert for the Flysky FS-i6 or FS-i6x. Sized to print on a MK3 or MK4.
I glued some foam to the lid of the case and created an insert for the base of the case.
The Case
The case is a version of https://www.printables.com/model/258431-rugged-box-parametric
With the following parameters
The STL files for the case are included . You need to print:
1 x Box Base
1 x Box Lid
2 x Box Latch
Optional 1 x Seal in TPU
To Assemble:
6 x M3 30mm Screws
The Insert
The flysky receiver sits in the insert at an angle because the transmitter handle is angled. For me this works well as I can place a cable underneath the transmitter. However if you want to change it, I have included the Fusion 360 file for the insert.
The insert is a close but not tight fit. I would suggest some glue to hold in it place. If its too tight its extremely difficult to insert for a test fit. I had to break an insert to get it out.