1 / 4
Lampenzieher Lamp extractor remover T1 3/4 5,5 mm | 5,6 mm 5,3 mm 5,0 mm — zdjęcie 1
1 / 4

Lampenzieher Lamp extractor remover T1 3/4 5,5 mm | 5,6 mm 5,3 mm 5,0 mm

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Tool to remove T1 3/4 lamps from their sockets. Different sizes because they are all lamps are little bit different.

Ocena
0 / 5
Polubienia
1
Pobrania
14
Wydruki
0
Wyświetlenia
125
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Share Alike

Tool to remove T1 3/4 lamps from their sockets.

Just push the tool over the glass part of the lamp (or plastic part if it is LED) and then pull the lamp to extract it.

Different sizes because they are all lamps are little bit different.

Those lamps are also called midget groove lamps.

I made them in diameter sizes 5,0 mm, 5,3 mm and 5,6 mm. The nominal socket size is 5,5 mm, but there is tolerance for the lamps production wise.

 

Print in flexible filament! (I printed them in 95A-TPU)

I used 0,12mm layer height (first layer 0,2mm) but probably 0,2mm for all of them would have also been fine.

All of the different sizes were able to extract my lamps.

But since production batches can be different I made three sizes to hopefully have at least one working suction tool.

 

The diameter is printed on the lower side of the model.

I printed the model with the numeric text (size) on the bottom with no supports.

Tagi