Kitchen Utensil holder with anti-slide-off grooves
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remix of a really cool model. Added anti-slide-off-grooves so that heavier spoons etc. don't run off the holder.
- Ocena
- 4,75 / 5
- Polubienia
- 57
- Pobrania
- 225
- Wydruki
- 4
- Wyświetlenia
- 991
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Kitchen
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
According to a user's request from the comments, I made three size version (the photo shows the “large_spoon_size_kitchen_utensil_holder_with_anti-sliding_grooves_64mm_between_posts_center”-size.
There are also versions with “flatter_bottom” at the end of the filename now.
They are easier to print since the first few layers had a steep overhang. I prefer a little less curvy than a bad print. My printer could not handle the steep overhangs of the rounded model - maybe yours can!
It might be a good idea to fill the model with something to give it some weight (infill, plaster, …) for better handling.
I also put some self-adhering rubber feet on the bottom for better grip
This is a remix from :
https://www.printables.com/model/719988-utensil-holder
My print settings for a hopefully long lasting part:
PETG to have better temperature resistance with 4 vertical perimeters and 1.6 mm horizontal shell thickness.
First layer 0.28 mm, others 0.2 mm.
Only on the two main beams I use a 50% grid infill via added modifier in PrusaSlicer. For the rest I use 0% infill (yes, zero) because of the good strength with the vertical perimeters.