ATorch DL24 Load Tester - Complete Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Case for the ATorch DL24 Battery Load Tester
- Ocena
- 4 / 5
- Polubienia
- 24
- Pobrania
- 324
- Wydruki
- 0
- Wyświetlenia
- 2333
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
Complete case for the Atorch DL24 battery tester. Unlike other cases I found, this covers the heatsink and fan. This may not work with some larger fans out there, so your mileage may vary. I'm personally using it with an 80mm Noctua fan and the stock heatsink.
Hardware required:
- 4x M3x4.5mm heat-set inserts for middle case
- 4x M3x10mm countersunk screws for bottom case
For the bottom, it's recommended to print the bottom case (dl24-case-bottom) separately from the feet (4x dl24-case-foot), and then gluing on the feet. However, a full bottom case file is available (dl24-case-bottom-with-feet). As a bonus, print the feet with TPU for some vibration damping.
For the middle, it's recommended to print the middle case (dl24-case-middle) separately from the top (dl24-case-top), and gluing them together. However, they are available combined (dl24-case-middle-top).
Print 4 of the buttons (dl24-case-button) and insert them into the middle case upside down, then place the DL24 in to hold them in place.
Material: PETG or ASA
Infill: 15%+
Supports required for:
- dl24-case-middle
- dl24-case-middle-top (if you decide to print the middle and top together)