Bicycle Pannier Hook for 10mm Tubes
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pannier hook fits most racks! Designed for SLA printing.
- Ocena
- 0 / 5
- Polubienia
- 16
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 1161
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Public Domain
This is the 7th iteration or so of the bicycle pannier hook design!
Printed and tested in Siraya Build resin, should work with most tough resins. Not designed for FDM printing, but may work if you orient correctly.
Two hooks tested to about 6kg by dropping off curbs at various speeds.
I printed it with the opening of the hook facing away from the build plate, which left no support scars on that part of it and maximum tolerances.
The clip covers a little more than 180 degrees of the rack tube, so it actually “clips” on positively. I back it up with some ribbon threaded under the clip just to keep the bag from falling off if the clip fails or it bounces off.