Rifle Collator With better Tube Stops
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The only thing I did was add better tube stops to the rifle version. For some reason I did not have any when I printed…
- Ocena
- 5 / 5
- Polubienia
- 3
- Pobrania
- 43
- Wydruki
- 1
- Wyświetlenia
- 207
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
The only thing I did was add better tube stops to the rifle version. For some reason I did not have any when I printed it up. This thing is awesome!
I can verify it works with:
223 / 5.56
300 BO
7.62x39
308 / 7.62x51
As the case size increases, feeding will slow a bit as expected.
Like what you see and find it useful? Buy me a beer
Print Settings
Printer:
Ender 3ish
Rafts:
No
Supports:
Doesn't Matter
Resolution:
.2
Infill:
20%
Filament:
Any PLAAny Post-Printing =============
Copied for original for ease of use
"I printed it upside down for better bed adhesion. Needs support for greater than 60 degree surfaces. (inside horizontal surface)
-EDITMost comments have indicated people are printing this (Successfully) right side up with supports to keep the inside of the funnel smooth. My printer does 45 degree overhangs smoothly if I keep the layer height less than half the nozzle diameter. Therefore I only supported the bottom of the funnel and the slightly rough surface that results does not noticeably affect the operation. It appears print orientation is entirely your choice."
Category: Other