Grohe showerhead-holder 40mm Clamp-ring
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Tiltable showerhead holder for our Grohe Shower, with a somewhat non standard head.
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 208
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Bathroom
- Licencja
- Creative Commons — Attribution — Noncommercial
Tilt able showerhead holder for our Grohe Shower, with a somewhat non standard head.
The “showerhead holder clamp” fits 20 - 24mm diameter.
The screw-on.. thing has a main-bore of 16mm and the lugs with a diameter of 20mm. The clamped radial part is 40mm in diameter.
Added some filets to reduce overhangs and optimize the printing process.
No Supports needed.
Printed in PLA with .25mm layer height and 15% infill seems to work fine with a .6mm nozzle.
(But it should be fine with every other nozzle tbh, as there is nothing fancy going on here.)
PLA should also be sufficient, had another (barely fitting but… existing) clamp printed from PLA there for the past months and it was fine, not getting soft etc.
This is a work in progress, but I might stick to mediocrates ("meh'.. good enough")
Added the step file, feel free to modify it.
(And be warned, there IS a lot of room for improvement here ;))
(Fixed an issue with a broken wall)