BitKit2 Arcade PCB Enclosure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
If you're looking for a case for your BitKit2 FPGA Emulator, you're in luck!!!
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 312
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Video Games
- Licencja
- Creative Commons — Attribution — Noncommercial
My print was done with in PLA and did not need any supports.
There are two versions of the case. the first (and my favorite) has two screws that mount the PCB to the front of the case. This one just does a better job of holding everything in place.
The holes fit M3 Screws, I used 6mm since that's what I had around. the hole is about 14mm thick so you can use anything in between.
The second version has small posts that fit into the mounting holes. they do an good job of keeping the PCB from sliding down but I wouldn't want to tug on it too hard or they may break off.
The Volume pot on the board has a flat spot that lines up to the base of the knob. put the knob in the hole first, install the PCB, then turn the dial slowly until it pops into place. Once the back of the case is on the pressure keeps everything in place and the volume knob turns nicely as long as you don't crank past the start or end point.
For a decorative touch you can print the “BitKit” letters in a differnt color and paste them into place. I print them face down to give them a more smooth look.