MUFGA Indoor Hydroponic Gardening System - Support Rod Hole Plugs
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Prevent algae growth while making your system run quieter at the same time with these simple plugs.
- Ocena
- 5 / 5
- Polubienia
- 11
- Pobrania
- 84
- Wydruki
- 1
- Wyświetlenia
- 1640
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — NoDerivatives
So you have a MUFGA or IDoo Indoor Hydroponic Gardening System, yeah?
You should be familiar with the plant support rods that come with these systems.
Have you ever looked down the holes where these rods are placed?
If not, take a look. You'll notice that you can see water. These holes go straight through into your water reservoir.
It seems this is by design seeing how the support rods are also follow. The thought assumed here is to allow more air into the tank for water aeration?
However, having open holes on the plant deck allows light into the reservoir. Just like leaving unused plant holes open can lead to algae growth in the reservoir, so can these little rod support holes.
Plugging the holes is the solution!
Not only will these plugs help block light from getting into the reservoir, but it will also reduce the noise levels of the water while the pump is running! So it's a win/win!
Don't have a 3D Printer? You can purchase the plugs here.
Print Settings
- Printer Brand: Creality
- Printer: Ender-3 v2
- Rafts: No
- Supports: No
- Resolution: .2 mm
- Infill: 20%
- Filament brand: Hatchbox
- Filament material: PLA
Print the plug with the head/top on the build plate.
NOTE - You may need to trim the z-seam with an xacto knife so the fit isn't too tight.