Skadis Plier Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed this hex pattern caliper hanger into one that can hold two pairs of small pliers or snips to keep them handy.
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 55
- Wydruki
- 0
- Wyświetlenia
- 714
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I liked the look of the original caliper hanger so much that I decided to make a few additional models with the same look and feel of the original. This one was modified to hold two pairs of pliers vertically. This uses the same mounting hooks and hexes that the original uses.
The model can be printed in either PETG or PLA, but I recommend printing the hooks from the original source in PETG, and solid, for strength and the slight flexibility PETG tends to have over PLA.
The hexes can be a bit snug, especially if your printer has any sort of elephant-foot going on when it prints, but a deburr tool or a nail file is usually enough to make for a snug fit.
This is intended for use with an Ikea Skadis pegboard, but the hooks can easily be adapted or swapped for use with other pegboard systems.