GoPro Hero2 Tripod Mount and Frame
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I needed a frame for GoPro HERO2 and found this complete solution on Thingiverse. Re-uploading here for preservation.
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 39
- Wydruki
- 0
- Wyświetlenia
- 174
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Photo & Video
- Licencja
- Creative Commons — Attribution — Share Alike
Original instructions
The base requires an M5-.8 hex nut. The knob is built for a M5-.8 hex bolt, 50mm in length. The screw and nut were chosen to be compatible with GoPro's hardware. As a result, you can elect not to print the "Knob" and just use a GoPro knob that you likely already have.
The Frame is printed with 2 shells, 20% infill, a 0.2mm layer height. Supports must be used. You will need to clean up the part with an Xacto knife to remove the supports from the cutouts in the frame.
The Base is printed with 2 shells, 20% infill, a 0.2mm layer height. Supports are recommended when printing (only used to help with the screw hole). Removing the supports from the hole is easily done with an Xacto.
The Knob is printed with 2 shells, 20% infill, a 0.2mm layer height. Supports are not needed.
Note: The units of the STL files are in inches.