Ghostbusters 2016 Proton Pack- Toolbox/ Cryogen Chamber Lid

This was made using in film reference, notes from crew, as well as detailed photos of the SDCC proton pack and the Olympia pack. Scaled from references based off of known objects on the pack taking into account perspective distortion and other factors, Measurements were crossed checked among different sources to ensure accuracy.

I can not guarantee this is 100% of course with out first hand access to the real thing but it should be very close. And I hope it helps the prop builders out there.

Note: the side bolts change positions from pack to pack, this positions I based off of the SDCC Holtzmann pack, The top rivets appear to be consistent among different packs with the exception of the pack that has the proton guns slide out of the side as that pack has more rivets and appears to be a bigger box in general for the scene.

Included are different handles in different stages of completion, so if you wish to tweak this design (as I don't feel it is 100% exact yet) I hope these tools will help.

Handle that is centered above the lid is made to fit a handle hole that is 5 inches wide, 2 inches tall, and a half inch deep.Designed to be used with a 4mm cap bolt, the head of the cap bolt should recess about half way into the side holes just like on the screen used packs, and the bolts will thread into the handle itself allowing it to be held in place and move freely without nuts on the other side.

How I Designed This

This thing was made with Tinkercad. Edit it online https://www.tinkercad.com/things/iAe5l9pZVzb

Custom Section

Category: 3D Printing