1 / 1
X-Maxx Spur to Traxxas Rustler 2WD Slipper Adapter
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
X-Maxx Spur to Traxxas Rustler 2WD Slipper Adapter
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 58
- Wydruki
- 0
- Wyświetlenia
- 446
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution
I needed to fit an X-Maxx spur gear to a Rustler 2WD gearbox, so I made this simple adapter.
Use M3 x 7mm screws. Stock pads will fit, but metal pads are recommended to dissipate heat better.
I printed in bridge nylon, 20% infill, 2 perimeter, gyroid infill. I have fit the stock X-Maxx 54T spur and a Hot Racing 47T spur onto this.
Print on flat face with supports. Pads should snap on.
Print Settings
Printer Brand:
Prusa
Printer:
i3 MK3
No
Supports:
Yes
0.2
Infill:
25%
Filament:
any Nylon, any temp-resistant material
Category: R/C Vehicles