1 / 3
Heart Pin Challenge — zdjęcie 1
1 / 3

Heart Pin Challenge

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Orientacyjna cena wydruku pliku

0,09 € – 0,11 € netto (bez VAT)

Dla pliku: Heart-pin-challenge.gcode

To wstępna wycena jednego pliku. Dokładną cenę poznasz przed zamówieniem.

Plik i założenia wyceny

Plik użyty do wyceny

Średnia wycena orientacyjna: 0,10 € netto (środek widełek).

Masa podana przez autora
2 g
Czas druku podany przez autora
4,2 min
Materiał u źródła
PLA
Materiał wyceny
PLA
Drukarka wyceny
Bambu Lab P1S - 0.4 nozzle
Proces wyceny
0.20mm Standard

Orientacyjna wycena wyłącznie wybranego pliku, oparta na masie i czasie druku podanych przez autora. Warianty plików nie są sumowane. Ostateczna cena zostanie obliczona po analizie pliku.

Zapisane na tym urządzeniu.

Pin-Support Challenge but with a Valentines twist

Ocena
5 / 5
Polubienia
5
Pobrania
141
Wydruki
1
Wyświetlenia
649
Oceny
1

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Test Models
Licencja
Creative Commons — Attribution

Does Your Printer Love You?

This print takes the original Pin-Support challenge and adds a valentines twist, this will test your printers cooling, bed adhesion and its love for you (or your love for it).

This print is inspired by the Pin-Support Challenge at: https://fullcontrol.xyz/

The challenge tests bed adhesion and cooling very well, it also shows clearly the limitations of a one sided cooling duct such as on my Ender 3 (as seen in photos). This challenge is not much more difficult to the original pin challenge however is a little harder due to the heart shape and I'm sure you get much better results with better cooling fans/ducts.

This gcode was designed after looking into the gcode for the Pin-Support Challenge and doing some of my own research. First the model was designed and then sliced, I then edited this file in order to obtain the upward “pin” movement. 

Then there was testing… A lot of testing…

After much tuning and editing I finally ended up getting a result I was happy with, I finalized my gcode and readied it for sharing.

 

All the print settings are handled for you in the gcode.

This gcode file was originally sliced for an Ender 3 however should work on any printer with a print volume larger than 10x10x10cm

Please note that it is recommended you check this file in a slicer prior to printing.

Good Luck!

Tagi