Wall / desk holder for tool bag (Engelbert Strauss e.s. motion ten)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A mount/holder for the e.s. motion ten tool bag by Engelbert Strauss
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 32
- Wydruki
- 0
- Wyświetlenia
- 346
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Engelbert Strauss makes amazing tool bags that attach to your belt with magnetic clips. They can be easily by using a pull tab but sit amazingly secure otherwise. https://www.strauss.global/bags/tool-bag-e-s-motion-ten-7901480-6315772-1199.html
Whenever I am stationary at the office, there is no need to carry the tool bag on my person. I therefore designed a holder that you can screw to the wall or the desk (using 3,5x40mm screws).
When using normal, ferromagnetic screws, the magnetic counterpart on the bag snaps into place and hold the bag securely.
For printing, the best way seems to stand it on one of the sides (as shown in the last attached screenshot). This gives most strength and removes the need for support. I have printed a few several months ago and they have held up just fine despite of being "only" printed in PLA+. For heavy load, you should probably choose a different type of filament.