sBITX tilt legs for portable operations.
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
sBITX tilt legs for portable operations. Created with OpenSCAD so you can easily modify the design.
- Ocena
- 0 / 5
- Polubienia
- 5
- Pobrania
- 82
- Wydruki
- 0
- Wyświetlenia
- 486
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
sBITX tilt legs for portable operations. Attaches to back to tilt screen back 30 degrees. Folds up when not in use. Folded does not extend beyond heat sink so does not add to the radio depth.
Not as sturdy as the sBITX V2/3 stand, https://www.printables.com/model/496717-sbitx-v23-stand, but easier to use portable.
You will need 2 M3x20 screws for the hinges and 3 M4x12 screws to attach to the back of the sBITX case. Assemble with round part of leg in so flat back will hit the leg angle stop.
Just fits the width of a Prusa Research MK3s.
I printed this in PETG using three perimeters and 25% gyroid fill. I printed the legs edge down to have a nice, clean screw hole without supports. I used supports for the back.