ELEGOO Neptune 2/3/4 Side Rail Raspberry Pi Zero 2 + HD Camera Mount + Light Fixture
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple camera mount for an Raspberry Pi Zero and the original Raspberry Pi HD camera, incl. an USB floodlight holder
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 116
- Wydruki
- 0
- Wyświetlenia
- 2684
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This model attaches to the siderails of a ELEGOO Neptune 2 / 3 / 4 extrusion without any other tools. Small screws are needed to attach the camera holder to the stand and the Raspberry Pi Zero to the case. Everything goes together a one piece. Print with PLA. This is easy to print.
Build Instructions
The Side Rail Mount can be printed and assembled without any tools. Remove the left two screws from front cap of your ELEGOO Neptune printer, slide the bottom piece of the side rail mount in (can be done by gently bending the plastic, be careful not to snap it!), afterwards the rest of the pieces can be attached with the printed nuts. Small magnets can be fittet / glued into the base of the top piece, before attaching the cap.
The Camera Stand comes in two variations: forward leaning and reversed. The reversed stand provides a little more headroom and was used in the pictures. A flat washer can be pressed / glued into the base of the stand, it will snap onto the magnets attached to the side rail mount top piece.
The Raspberry Pi HD Camera Mount exactly fits a original RPi HD Camera Module and a Yizhet USB dimmable light which I found on amazon to use as a floodlight. The camera is attached to the mount and then screwed into the camera stand. I soldered a small USB cable onto the USB light to attach it to the Raspberry Pi.
Last the Raspberry Pi Zero is attached to the case with screws, connected with the camera and light, then the small attachment Bracket is press fitted into the holder and pushed into the side rail mount holes. That is it.