Stabiliser for XP-Pen Innovator Stylus Pen Cap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is an inkwell type support for the screw top stylus support supplied with the XP-Pen Innovator graphics pad
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 42
- Wydruki
- 0
- Wyświetlenia
- 475
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution
This is an inkwell type support for the screw top stylus support supplied with the XP-Pen Innovator graphics pad.
I wanted something to support and give some weight to the screw top pen support and designed this simple thing in Fusion 360. The f3d file is included. The design is parameterised so you can change any of the heights, diameters, hole size or fillet radius. The screw cap pushes into this support and the hole for the cap goes right through to make it easier to remove.
I printed it with Eryone marble PLA filament which came out rather nice; if I printed it again I'd iron the top surfaces. I used 0.2 quality layers with 15% infill, it took 2.75 hours to print. I might later stick on some felt type stuff to the bottom to stop it sliding on the desk - not a big problem.
Before I printed the whole thing I did number of trials to test the hole diameter by using Prusa Slicer to cut off a bit of the top and then just print that bit. I finished the trials with a diameter of 32.2mm which on my Prusa Mini and this filament gave a snug fit. The threaded end of the cap has the largest diameter.