1 / 5
Patin antidérapant coque Amiga 500 / Amiga 500 case anti-slip foot — zdjęcie 1
1 / 5

Patin antidérapant coque Amiga 500 / Amiga 500 case anti-slip foot

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

FR : Bonjour à toutes et tous, ceci est mon premier essai d'impression en TPU (TPU-85A NinjaFlex), non sans mal je…

Ocena
0 / 5
Polubienia
0
Pobrania
34
Wydruki
1
Wyświetlenia
164
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Computers
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

FR :

Bonjour à toutes et tous,

ceci est mon premier essai d'impression en TPU (TPU-85A NinjaFlex), non sans mal je dois l'avouer.

Il s'agit de patins (pieds) de remplacement de la coque de l'Amiga 500 .

les dimensions du patin sont les suivantes :

  • hauteur totale : 5mm
  • partie côté coque de l'Amiga :
    • diametre 13mm
    • hauteur 1.5mm
  • pied
    • hauteur 3.5mm
    • diametre 11 millimètres puis 10.30mm sur la partie qui touche le "sol"

L'impression a été faite sur une Artillery SideWinder X2 et non une X1 (pas disponible dans la liste Thingiverse)


EN :

Hello all,

This is my first attempt at printing in TPU (TPU-85A NinjaFlex), not without difficulty I must admit.

These are replacement pads (feet) for the Amiga 500 case.

the dimensions of the foot are as follows:

  • total height: 5mm
  • Amiga case side part :
    • diameter 13mm
    • height 1.5mm
  • foot
    • height 3.5mm
    • diameter 11 millimeters then 10.30mm on the part that hits the “ground”

The print was made on an Artillery SideWinder X2 and not an X1 (not available in the Thingiverse list)

*NB : (partially translated using Google Translation, i'm sorry if it's not clear, send me a message to correct what is wrong)*

Print Settings

Printer Brand:

Artillery

Printer:

Artillery Sidewinder X1

Rafts:

No

Supports:

No

Resolution:

0.2mm

Infill:

100%

Filament: NinjaFlex TPU-85A Snow


Notes:

Impression à 20mm/s
pas de rétractation

Plateau à 40°

Température d'impression à 220°

Print speed at 20mm/s

No retractation

Bed à 40° Celcius

Print temperature at 220° Celcius

Category: Computer

Tagi