Chain Link Components (Tweaked)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
In the beginning, I was getting frustrated with my inability to get the little clips printed without creating a bird's…
- Ocena
- 5 / 5
- Polubienia
- 5
- Pobrania
- 75
- Wydruki
- 1
- Wyświetlenia
- 417
- Oceny
- 1
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
In the beginning, I was getting frustrated with my inability to get the little clips printed without creating a bird's nest on the build plate. As a result, I made a few minor changes to the original design of the chain links so that I wouldn't need the additional little clip. As a result, all you need to do is alternate how you clip them together around the ribbon cables. For the Kobra Plus, you will need 52 of the wide chain links (20 from the platform to the printhead & 32 from the base to the platform) and 27 of the small chain links from the base to the bed. If anyone can give me the #s for the Kobra Max, please message me with the numbers and I will post them here.
I've also included my Kobra Plus-specific versions of the PSU Cable Split and platform that fit the Kobra Plus and guide the ribbon cable and chain links from one angle to another at the location where my extruder used to be down to the base of the Kobra Plus. My Kobra Plus Direct Drive mod has the printhead's chain link end built it. It can be found here: https://www.thingiverse.com/thing:6316206
(Edit 2024.02.24) I've added my bed connector clip-on chain link cover. This cover, if and on if you have the same bed connector as the one pictured, slips over the bed ribbon cable and will simply clip into place with no removal of the original connector required. Please note that this cover will NEED supports due to the overhangs and you may want to use a resolution of .10 just to make sure it has all the strength it needs. This is the only part that deviates from the others in its print settings.
You can find the original design by UncleSash and the other parts you may need here: https://www.thingiverse.com/thing:5202027
Print Settings
Printer Brand:
Anycubic
Printer:
Kobra
Rafts:
No
Supports:
No for the Chainlinks & the Base Cable Split, Yes for the Platform & the Clip-on Cover
Resolution:
.20 for the first layer, .15 for the rest
Infill:
100%
Filament: GiantArm PLA Matte Navy Blue
Category: 3D Printer Accessories