1 / 2
Orange Pi 3 LTS Case - Ventilation, No Fan/Heatsink, T-slot
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Orange Pi 3 LTS Case - ventilated (no fan/heatsink), options for t-slot rail attachment
- Ocena
- 4,5 / 5
- Polubienia
- 15
- Pobrania
- 91
- Wydruki
- 2
- Wyświetlenia
- 465
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (4)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (10)Powiązane
This case has ventilation to run an Orange Pi 3 LTS with no fan or heatsink.
Options for T-slot rails on the side, bottom, or none. Download one ‘bottom’ piece to match your needs.
For my use running MainsailOS for klipper, this seems to be ok without a fan or heatsink. Running 50-60degC on the Orange Pi 3 LTS while printing.
Assembly instructions:
- Feed the board into the case top USB end first. Flex the case top as needed to lift over the power button and USB-C port.
- You can then feed the entire top and board together into the case bottom. You may need to start by angling the HDMI port down and slightly flexing the case open to level out the board. Once the board is level in the case it should slide in with only slight interference of the HDMI and audio ports until it seats in its opening.
- Use four M3x10 (or M3x8) Flat head screws to secure the top and bottom halves and complete the assembly.
