amplifier connector for BMW vehicle
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a 3d printable connector that allows you to replace the rear amplifier in a E46 BMW Harman Kardon system.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 305
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a 3d printable connector that allows you to replace the rear amplifier in a E46 BMW Harman Kardon system. No need to cut off the connector or splice wires, just plug and go. The factory retention and eject system for the connector is retained. This connector also applies to other cars (BMW) with the same audio system.
I used a dual row 0.1" pitch header with some pins removed for the electrical contacts. The header was soldered to a carrier PCB and the wiring was then fanned out to the rest of the components. The .stp file is included for those that wish to modify the connector.
Print Settings
Printer Brand:
Wanhao
Printer:
Duplicator 6
Rafts:
No
Supports:
No
Resolution:
.4mm line width, .2mm layer
Infill:
25%
Category: Automotive