1 / 11
Makita MAC700 Air Compressor Feet With Penn Championship Extra-Duty Felt High Altitude Ball's — zdjęcie 1
1 / 11

Makita MAC700 Air Compressor Feet With Penn Championship Extra-Duty Felt High Altitude Ball's

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

I needed to lift the compressor feet off the ground. The original rubber feet screw & Washer was scratching the floor

Ocena
0 / 5
Polubienia
12
Pobrania
28
Wydruki
0
Wyświetlenia
476
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial

I needed a different type of feet for my Makita MAC700 air compressor to keep the original rubber feet from rooting and the screw & washer from scratching my wood floor. I fount that https://www.printables.com/@CymenVig_234754 “The California Air Tools 1P1060S compressor antivibration feet” were to small for what I needed. This is why I created the four antivibration feet for my MAC700 air compressor.

I used these “Penn Championship High Altitude Tennis Balls - Extra Duty Felt Pressurized Tennis Balls” for high altitudes, here is the link: https://www.amazon.com/dp/B003ILP9PY?ref=ppx_yo2ov_dt_b_product_details&th=1 

I used 100% infill to make it more sturdier.

 

To install: 

  1. Take each rubber foot off of the air compressor, don't lose the screw & washer if they come out
  2. Push the rubber feet with the screw & washer thru the printed feet
  3. Screw all four of the new feet back onto the air compressor
  4. Insert a tennis ball into each one, then flip over

 

 

 

Category: Tools

Tagi