T12 Makita soldering station - top box
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
this is the case for a T12 soldering kit with a simple standard on/off switch
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 81
- Wydruki
- 0
- Wyświetlenia
- 844
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution
English:
this is the top part of a mobile soldering station with the T12 (item STC-T12)
what you need:
a makita 18V battery, makita battery mount with Makita adapter piece 6438386
T12 soldering kit with PCB and soldering iron
a switch for 6mm mounting hole
2 M4x15 screws with countersunk head
2 M4x30 screws or M4x32 with countersunk head
4 M4 hex nuts
usually there are some wires in the T12 kit, so no need to get something for the switch
optional: stand for the T12 iron
and of course you need a soldering iron to solder the soldering station together
there are two versions.
With "A" the hex nut is nicely flat on the surface, but you need a 32mm screw
With "B" the hex nut sits 2mm deeper, so you can use a standard 30mm screw
for the short screws both use 15mm
Information regarding the bottom part / makita battery mount can be found here:
https://www.thingiverse.com/thing:352094
Beware, this part does not fit 100%. I printed with thicker walls and use a file to make it fit.
Deutsch:
Hier gibt es den Oberteil der mobilen T12 Lötstation (Artikel STC-T12)
benötigte Teile:
einen Makita 18V Akku, Akkuhalter mit Adapterplatte Makita 6438386
ein T12 Löt Set mit Platine und Lötkolben
einen Schalter mit 6mm Montagedurchmesser
2 Stk M4x15 Senkkopfschrauben
2 Stk M4x30 oder M4x32 Senkkofschrauben
4 Stk M4 Mutter
In den T12 Kits sind normalerweise genug Drähte vorhanden. Sollte für den extra Schalter reichen
optional eine Halterung für den Lötkolben
Und natürlich wird ein Lötkolben benötigt um die Lötstation zusammen zu löten
vom Oberteil gibt es zwei Versionen
Bei Modell "A" sind die Sechkantmuttern Oberflächenbündig versenkt. Hier wird allerdings eine M4x32 Schraube benötigt
Bei Modell "B" liegen zwei Sechskantmuttern 2mm tiefer, damit die M4x30 Schrauben gut passen.
Alle Information zum Unterteil bzw. Makita Akku Adapter gibt es hier:
https://www.thingiverse.com/thing:352094
Der Adapter passt nicht zu 100%. Daher hab ich die Wände etwas dicker gedruckt und das überschüssige Material an den richtigen Stellen weg gefeilt.