Mini Lathe Centre Drill Storage Holder
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A small rack to accept one each of BS1 to BS4 centre drills
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 68
- Wydruki
- 0
- Wyświetlenia
- 305
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Simple holder to make the centre drills I keep around my Chinese mini lathe tidy and accessible. The hook section is shaped to fit over the angled top edge of the chip tray / splash guard.
The model was drawn in Design Spark Mechanical 6.0 and sliced with PrusaSlicer 2.7.1.
Printed on a Creality Ender 5 S1 in around 2 hours and 9 mins, using around 7.5m of 1.75mm PLA filament when set to 5% gyroid infill with a 0.4mm nozzle and 0.2mm layer height.
Printing with the ‘holes down’ orientation means supports are not required (relies on good adhesion to the textured PEI build plate though). I guess bed slinger may need a brim.
I’ve no doubt it could be done much faster, but my preference is to dial everything back to get a decent print first time, rather than wasting filament on failures just to push the envelope.