Custom Parts For @Chad_35259 Car Stand

Power Supply I used (I have the older version): https://www.racedayquads.com/products/rdq-power-supply-400w-16-7a-24v-plug-and-play-for-isdt-chargers-and-others?keyword=power%20supply

buck converter for 24 → 12v for the lights: https://www.amazon.com/gp/product/B00LSEBYHU/ref=ppx_yo_dt_b_search_asin_title?ie=UTF8&psc=1

buck converter for the 12v - 5v for the tablet: https://www.amazon.com/dp/B08H89LTP5?ref=ppx_yo2ov_dt_b_product_details&th=1

waygos: https://www.homedepot.com/p/WAGO-221-415-996-010-5-Wire-Lever-Nuts-Conductor-Compact-Splicing-Connectors-12-24-AWG-10-Pack-60343607/318073858

tablet I used: Samsung Galaxy Tab A 8" SM-T378V
(the tablet stinks… pulled it from a junk drawer…)

Bottom Wire Management - This attaches to the front of the extrusion and gives a channel on the left of the stand to run large AWG through. I used this to run 12AWG from the PSU to my xt60 (that feeds a charger). 

Buck Extrusion mount - Attaches the variable buck to the extrusion. sink M3x6x5 heatset inserts into the holes in the corners. This also holds the top of the psu to the frame.

Handle - this stinks and is super small and weak. Trust it at your own peril. I need to beef it up but im lazy

Male xt60 - This allows you to mount a male xt60 to the frame. i run this off my psu and then plug my charger into it with a female → female xt60 cable (remember, “male” means the pins are male, not the plastic housing… this is the “female” plastic housing, male pins)

base psu mount - holds bottom of psu to frame

tab case back - this is the back of the case for the tab. its intentionally about 2mm too thick. Use foam tape from the original post to get a good fit. this was easier that getting exact measurements (im lazy, remember?)

tab case front - guess what this is for…

top wire management - this is wire management, same as the bottom one, but for the top. has a cutout so you can run wires to the waygos.