Slotted yarn carrier for Gearhart CSM (revised)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
USE VERSION 2 Slotted yarn carrier head to replace the original (non-slotted) on a 1925 Gearhart Circular Sock Machine.
- Ocena
- 0 / 5
- Polubienia
- 24
- Pobrania
- 54
- Wydruki
- 0
- Wyświetlenia
- 612
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
USE VERSION 2
Slot is larger - the original screw will now fit. Support only needed “build plate only” Holes and slots have printed fine without supports.
Version 2 was printed on a Bambu P1S. Only the slanted side slot needed a little cleaning up. Holes and front slot clean.
Remix from https://www.thingiverse.com/thing:5258896 which was a remix from Mr. Roboto's CSM: https://www.thingiverse.com/thing:4695746
Remixed to fit on the Gearhart vintage CSM existing yarn carrier bar
Version 1 notes: I used minimal support for holes, slanted slot, and under the base, with .2 contact Z distance (Prusa Slicer) and they came right out. Probably did not need supports for the holes.
I had to adjust the height and forward position on the carrier bar, as with the original. Replaced carrier head adjustment screw with nut and bolt that would fit in the slot - sorry, I don't know the size.
I used a round hobby sanding file (320 grit) available at Hobby Lobby to smooth out any burrs in the holes.