Guitar (TRS) Patch Cable Pancake Connector Soldering Jig
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A soldering jig to hold a right angle pancake connector (like those used on patch cables in guitar pedalboards) in place
- Ocena
- 4,5 / 5
- Polubienia
- 43
- Pobrania
- 143
- Wydruki
- 4
- Wyświetlenia
- 1135
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Share Alike
This is a soldering jig designed to hold a ¼ inch right angle flat pancake connector in place. These connectors are typically found on patch cables on guitar pedalboards.
This jig holds the instrument cable at the correct height for easy connection, and has lots of mounting options to hold down the cable. A rubber band can be attached to the hooks on the side, a ziptie can be passed through the hole in the bottom, and a small binder clip even fits perfectly upside-down on the hooks and pinches the cable down.
This is an easy print; the only supports you need are under the side hooks.
Includes a screw holder tray to avoid losing screws while the connector is disassembled.
Original Version has a 6.45mm hole, which fit perfectly printer on my MK3S. Larger version has a 6.85mm hole which should work for printers which need higher tolerances.