Watch Strap
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is a watch strap designed to replace 20-22mm wide watch straps. If your watch strap has broke than look no further!
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 40
- Wydruki
- 0
- Wyświetlenia
- 501
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution — Share Alike
This is a watch strap designed to replace 20 - 22mm wide watch straps. If your watch strap has broke, been damaged, or you don't have a strap for your watch, his might be the thing you need! it takes about 3h to print and can be an elegant solution to your watch dilemma.
If you need to fit a 22mm watch use WIDEBAND and if you need to fit a 20 or 21mm watch use BAND
Print Settings
Printer Brand:
ELEGOO
Printer:
ELEGOO NEPTUNE 3 Pro
Rafts:
Doesn't Matter
Supports:
No
Resolution:
0.15mm
Infill:
10%
Filament: Sunlu TPU and PLA Red and Silver Post-Printing =============
Step 1:
Gather these things:
* a watch face and 3 watch pins * the two watch straps * the watch clasp piece's * the band holderStep 2:
take the longer watch strap and slide the pin through the hole on the flat end. then pop the end of the pin into the watch lug and make sure that the strap is facing up. press down the pin and slide it into the other lug.
Step 3:
Repeat with the other strap
Step 3:
take the holder and put it onto the shorter strap.
Step 4:
find the shorter band and locate the notch at the end. put the clasp arm into the notch and slide the last pin through. finally, take the other part of the clasp and pop it over the ends of the pins.
Category: Other