1 / 4
ICOM ID-4100A Mobile Dual-band Amateur Radio Desktop Stand — zdjęcie 1
1 / 4

ICOM ID-4100A Mobile Dual-band Amateur Radio Desktop Stand

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

This is a simple wedge-shaped stand for the ICOM ID-4100A dual-band mobile radio. It is designed to lift the radio off…

Ocena
0 / 5
Polubienia
12
Pobrania
89
Wydruki
1
Wyświetlenia
662
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Electronics
Licencja
Creative Commons — Attribution — Noncommercial

This is a simple wedge-shaped stand for the ICOM ID-4100A dual-band mobile radio. It is designed to lift the radio off a desk and make the screen/buttons more accessible. Given the relatively-close dimensions of the older ICOM IC-880H, it should work pretty well with that radio as well. This is the fourth revision to the design and is the only one I consider worthy of publishing.

I have designed a complementary enclosure for the Powerwerx SS-30DV power supply I use with this radio. It mates up to the bottom of this thing to create an integrated enclosure and stand system for the two units. Very handy for organizing/optimizing desktop space. That thing can be found here: https://www.thingiverse.com/thing:2981349

This model prints fine on my MakerGear M2 without rafts and without supports. I utilize Simplify3D to slice the model.

Print Settings

Printer Brand:

MakerGear

Printer:

MakerGear M2

Rafts:

No

Supports:

No

Resolution:

.2mm

Infill:

15%

Category: Electronics

Tagi