T'EYES CC3 2k bracket, LC100 98-02
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I made a simple bracket for mounting an oversize (11" or 13" in 2DIN) T'EYES CC3 2K headunit in the Land Cruiser 100…
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 433
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
I made a simple bracket for mounting an oversize (11" or 13" in 2DIN) T'EYES CC3 2K headunit in the Land Cruiser 100 99-02.
You will need screws, 4x M3x10 and 4x M3x20. Screws will thread their own holes. The long screws could possibly be exchanged for wood-screws.
I have mounted it, and it looked ok. Unfortunately, I did not take any photos, as I had to dismantle it again, due to wrong cables. But so far so good.
Print Settings
Printer Brand:
Flsun
Printer:
Flsun QQ-S
Rafts:
Doesn't Matter
Supports:
Doesn't Matter
Filament: Clas Ohlson PETG / ABS / ASA
Notes:
I used PETG, 18% infill, 3 layers top, bottom and 4 layers perimeter, 0.65mm extrusion width, 0.35mm layer height.
It needs to be solid enough to take some abuse.
PLA is not a good idea, as it will be too soft.
Use Mirror-function in slicer to get both sides of end-brackets
Update: Use flat side of updated rear-bracket towards updated end-brackets.
Category: Automotive