Creality K1 Max Top Sliding Glass Riser / Low-ride lift topRiser

1 Description

I wanted a riser for my K1 max since the reverse bowden tube keep on rubbing on the top riser. However, I want something that's unobstrusive and don't require opening/closing vent on the side. 

Most of the riser models online are a bit too tall for my preference and it makes the printer look ugly.

I found a slider riser model and I decided to make some small changes to make the slider more versatile.

This model can be used as:

1. Slider - You can slide your top in and out and it will fit snugly. You can partially open or fully remove the top as needed
    
2. Low-ride lift top Riser: You can use this like standard lift top riser but this is lower than other risers, just enough to provide clearance for the reverse bowden tube to not rub against the top lid.

2 Printing Instructions

1. Print all the rails with brims since this is pretty tall
2. Print the corner with support. I use tree support on Orca. See Screenshot

2.1 As a Slider

Print the following:

• 1 * HalfRailNotch - This will be mounted on whichever side you want the slider to slide out from eg: Front if you want to slide in front of the printer
• 2 * HalfCorner - Mount this to the corners next to the HalfRailNotch
• 3 * FullRail - Mounted on 3 other sides
• 2* FullCorner - Mounted on the rest of the corners

2.1 As a Lift Top Riser

Print the following:

• 4 * HalfRail
• 4 * HalfCorner