Air intake vent on door with magnetic closure
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Minimalist/contemporary style 2-sided air vent for a closet door to increase intake air flow to tankless water heater
- Ocena
- 0 / 5
- Polubienia
- 12
- Pobrania
- 45
- Wydruki
- 0
- Wyświetlenia
- 447
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Living Room
- Licencja
- Creative Commons — Attribution — Noncommercial
This 2-sided minimalist/contemporary style vent was designed to be mounted on closet door to increase air flow.
The best result from my machine comes from turning off IS - it maybe my own fault as I'm still trying to getting use to IS but I've attempted twice printing with IS sliced file and they both have layer shift issue on the larger file (room side file) . My final print was w/o IS and although the print time was much longer but both parts printed successfully the first go around.
For the magnetic closure - there's a slot on the furnace facing piece intended for a magnet (dia 6mm, t 3mm) N52 magnet to be press fitted into the slot. On the opposite piece, a small screw was used so magnet will attract to it - make sure the screw is ferritic & not the good stainless type as they're not magnetic. If a strong magnet is not available - you can probably use 2 magnets on opposing sides to make sure they will hold together