Lightsaber Butane Soldering Iron Grip
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Light saber Butane Soldering Iron Grip-for 25mm diameter x 97mm high tube
- Ocena
- 0 / 5
- Polubienia
- 14
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 265
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
*Additional* now comes with a stand with or without grip
https://www.printables.com/model/747091-star-wars-imperial-logo-butane-soldering-iron-stan
A Light saber Butane Soldering Iron Grip-for 25mm diameter x 97mm high tube.
obviously you can scale and stretch the model to fit your own.
*note* there are some built in bridge supports which will need cutting-see pictures (red sections)
This is so you don't need to any additional supports from the bed, I have also included a non supported version if you wish to add your own.
This model was printed at 0.15 layers.
*note* if you are new to printing you must have good retraction settings, if you find the print is falling apart then you have it set to high, probably best to set it low and you can always trim or burn off the wispy bits.