E-Thirteen, e*thirteen, ethirteen etc. LG1 Chainguide Idler
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Idler bearing housing TPU or PETG
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 61
- Wydruki
- 0
- Wyświetlenia
- 304
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
As the bearing of the idler began to wear down and get stuck it grinded down the rubber housing of the bearing. Instead of just buying a new one I just opened the bearing, cleaned and relubed it so that the bearing was fine. But i was missing a rubber housing for it. So I designed one from ground up. I made one for PETG “press-fit” since i only had PETG laying around but later made one with proper notches so that a TPU version won't slip of the bearing.
Hope it helps you like it did for me.
Needs no supports, but I had to print it with 101% on one of my printers while the other was fine with 100% so you maybe have to try some scaling.
I even made some version with proper gears but never printed them. Those need supports and I don't know if the gears fitting all chains out there. But the one without gears was working so well I never printed the gears one.