Tobii 5 - 1500R Mount

All the existing designs by other people seem to be for the more popular 1800R monitors. This one takes a similar approach, but for a different R measurement.

I have a Huawei Mateview GT 34", which is 1500R and nothing would fit, so i quickly whipped this up using maths and only primitives because i was too lazy to open blender, yet the end result is pretty good.

It fits snuggly on the lower bezel of my monitor using double sided 3m tape, then more 3m tape to hold the original magnetic bar to that, meaning the eye traker is still removeable via the magnets. I used specifically this stuff

It's also slightly angled upward because i'm an idiot with bad posture and sit with my chair raised to it's max while being close to the screen…

The 3MF file contains some pretty overkill settings and a 3mm brim resulting in a fairly rigid print, you can definitely lower the infil a bit if you want it faster and don't care about strength.

I do advise using a brim just to be safe, the ends get kinda thin after all.

just use standard PLA, it really doesn't need anything fancy

The STL file was exported from within bambu studio, no idea if it'll be any use but the option is there for you