1 / 1
Arrma Rear Lower Suspension Arma 148MM (ARA330654) | 3D Scanned
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
3D Scanned this part and edited it a bit. Screw holes can be a bit of a tight fit depending on your printer tolerances.
- Ocena
- 0 / 5
- Polubienia
- 20
- Pobrania
- 101
- Wydruki
- 0
- Wyświetlenia
- 559
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial
SzczegółyPliki (1)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (12)Powiązane
I 3D scanned this Arrma part and edited the holes a bit so it's printable. It is a little bit rough on the surface.
The printed one is on the left. It fits without any problems, screw holes are a bit tight but it won't strip your screw thread as it's plastic.
If you print this using Overture Easy Nylon it will be pretty strong.
Example is printed in PETG.
It is a bit rough because it's 3D scanned.